DynaVap M 2021

The best way to store your herbs is in an original TightVac MiniVac! After adding your herbs and closing the lid, push the button to pull the air out. Your herbs are now kept fresh and no smell is leaking out from the MiniVac. To open, push the button again and remove the lid.

The TightVac MiniVac has a capacity of 0,12 L which fits approximately 10 to 30 grams of herbs, depending on the herb density. Thanks to the innovative design it's extremely strong, completely airtight, and fully water-resistant.

The original On Balance Pocket Scale still retains its reliability and accuracy after all these years. Perfect for measuring your herbs or concentrates! The On Balance Champion weighs up to 1000 grams with a 0,1 gram accuracy. It fits in most pockets and can be brought with you everywhere! 

Capacity: 1000 g, 35,28 oz
Accuracy: 0,1 g, 0,01 oz
Units: g, oz, dwt, ozt
Auto shut-off: 60 seconds
Batteries: 2x AAA batteries (included)
Dimensions: 118 × 80 × 20 mm
Weight: 140 grams

The DynaKit: Deluxe by DynaVap is full of spare parts and cleaning products you can use to keep your DynaVap vape in top condition. Cleaning your vape is very rewarding and it also helps to keep the taste of your VapCap vapour optimal.

Included in this kit is the Cyclone II Triple Torch, a wind-resistant torch lighter perfect for heating your DynaVap vape, a fat mouthpiece, three titanium diffusers to filter the air, the DynaMag to provide touch-free handling of a hot cap, a small SnapStash to store herbs in and two storage tubes to transport your vape in.

To maintain your DynaVap vape this kit includes the DynaWax, five cotton pipe cleaners and two different sets of O-rings.

Includes:

• Cyclone II Triple Torch (empty) (1)
• Fat mouthpiece (1)
• Titanium CCD (3)
• DynaMag (1)
• SnapStash (small) (1)
• Storage tubes (2)
• DynaWax (1)
• Cotton pipe cleaners (5)
• Condenser O-rings (3)
• High-Temp O-rings (5)

The DynaKit: Deluxe is compatible with the following DynaVap vaporizers:

• DynaVap VapCap “M”
• OmniVap
• OmniVap XL
• NonaVong-S
• NonaVong
• NonaVong-XLS
• OmniVong
• OmniVong XL

DynaVap has revolutionized the VapCap heating with the new DynaTec Apollo 2 Induction Heater! Using an induction heater is a completely different way to heat your DynaVap VapCap as it doesn't heat your material with a flame, instead, it uses a protected coil to heat around the cap. The DynaTec Apollo 2 will work with both a stainless steel and a titanium tips and will reach temperature in only 5 to 8 seconds.

A switch is built into the chamber so that the heater will only activate when a DynaVap VapCap is inserted, indicated by a red light, and on top there is also a magnet to cool your cap more quickly after use which helps you to save more material.

Compared to using a torch, it heats to a lower temperature, so it’s perfect for flavour chasers and those who prefer cooler temperatures. For hotter draws, leave the vape in for an extra second or two after the click.

An auto-shutoff feature limits heating to a maximum of 15 seconds at a time to keep things safe. DynaVap provides a 12-month warranty period in case you experience any problems.

The DynaTec Apollo 2 Induction Heater will make your DynaVap VapCap easier to use, more convenient, and with better flavour - what more can you ask for?

Includes:

• DynaVap DynaTec Apollo 2 Induction Heater
• Power supply
• Two-prong EU-plug
• EU/UK-adapter
• Instruction manual

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The DynaVap DynaTec Orion Induction Heater is an extremely lightweight, portable, heating system made especially for DynaVap vapes. Enjoy flavourful and consistent vapour with your DynaVap VapCap wherever you go! The battery has a capacity of 1000 mAh which is enough for 50 heat-ups on average and it works with both titanium and stainless steel tips.

You don't have to worry about pushing any buttons as the Orion Induction Heater senses when the VapCap is inserted. To operate just insert the DynaVap VapCap into the chamber until you see the orange light blinking and listen for the click to indicate that it's heated (or count the blinks). In just four to six seconds your material will be heated to perfection and you'll be ready for luxurious, tasty vapour. An automatic shut-off feature limits heating to a maximum of 10 seconds at a time.

The included zippered case also fits not only your Orion but also the USB-C charging cable, the included SnapStash, and has room to safely store your VapCaps.

The DynaTec Orion Induction Heater is designed and assembled in the USA and comes with a 1-year warranty.

Includes:

• DynaVap DynaTec Orion Induction Heater
• DynaVap DynaTec Zipper Case
• USB-C charging cable
• SnapStash (small)
• Instruction manual

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The Vertigo Cyclone II Triple Torch is one of the most budget friendly torch lighters you will ever find. It features a large, clear fuel tank so you’ll always know how much fuel remains and it also makes refilling it a lot easier. The rounded design fits nicely in your hand while the dial on the base of the lighter easily adjusts the size of the flame with a quick turn. The wind resistant flame is capable of lighting at 3'500 meters above sea level.

Fill it with butane gas before use (not included). Do not clean with alcohol as this will degrade the plastic, resulting in fuel leaks.

The DynaStash is the perfect complement to a DynaVap vape. It has a large compartment to hold a generous amount of herbs which makes it super easy to load your DynaVap. All you have to do is press your DynaVap into the material, twist, and then you are ready to start vaping!

It also features another compartment to store your DynaVap, so you have everything you need (except the heat source) in one place. On top of the DynaStash is a strong magnet that can be used to store your DynaVap when not in use, as well as to help cool it down between hits.

Intended for use with: DynaVap M 2021.

The DynaKit: Maintenance helps you clean your DynaVap vape quickly and efficiently. The included DynaWax should be used to keep the O-rings well lubricated.

Since O-rings are small and easy to lose, this kit includes eight additional ones. There are two different types of O-rings that come with the DynaKit Maintenance; condenser O-rings and high-temperature O-rings.

Includes:

• DynaWax (1)
• Cotton pipe cleaners (5)
• Condenser O-rings (3)
• High-temperature O-rings (5)

• DynaVap VapCap “M”
• OmniVap
• OmniVap XL
• NonaVong-S
• NonaVong
• NonaVong-XLS
• OmniVong
• OmniVong XL

The DynaVap DynaCoil is designed to fit inside the Cap of your DynaVap vape letting you use it with your favourite concentrates or other sticky substances. To use it, all you need to do is to remove the herb screen from your cap, insert the DynaCoil, place your concentrate directly on the coil, heat, and enjoy.

Note that the DynaCoil arrives rolled up and shouldn't be unrolled for any reason.

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The DynaVap Fat Mouthpiece will fit onto the end part of all DynaVap models. It can be used as an extra mouthpiece for sharing among friends or it can be used as a water pipe adapter, fitting all female 14 mm connections which enables you to easily turn your DynaVap vape into a water-cooled vaporizer.

Please note - the Fat Mouthpiece will not fit into the opening of the DynaStash, you must remove it before placing your DynaVap into the DynaStash.

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The Stainless Steel Screens go in between the chamber and the tip of the VapCap to keep the vapour pure and free from fine particles from your herbs. These screens are compatible with both the titanium and stainless steel tips.

Includes:

• Stainless steel screens (3)

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The DynaVap Low Temp. Captive Cap provides a whole new experience with your DynaVap VapCap vape. By clicking earlier in the heating cycle, it helps you be more consistent with your heating times, enabling you to vape your herbs with less risk of combustion and enjoy a more complex flavour profile. The Low Temp. Captive Cap also comes with a unique logo on it to differentiate it from your standard Captive Cap.

The DynaVap Low Temp. Captive Cap was designed for the DynaVap VapCap M but will fit any VapCap. If you’re looking for cooler vapour, or want to experience more flavour from your herbs this is a great accessory to have.

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.

The new DynaVap Captive Cap helps keep the cap in place while also allowing for a more even distribution of the airflow. If you’ve ever had the cap get dislodged off of your DynaVap during a heat up, you’ll really appreciate the new design of this cap. The “click” you hear when the vape has heated up, or cooled down is also more distinct and easier to hear.

The DynaVap Captive Cap was designed for the DynaVap VapCap M but will fit any VapCap. If you’re looking for a replacement cap or just want something new, the Captive Cap is a great option.

Intended for use with: DynaVap M 2021 and DynaVap Omni 2021.